HP Cisco MDS 8/24c Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Rel - Page 41
Related Documentation
View all HP Cisco MDS 8/24c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Related Documentation Send documentation comments to [email protected] Workaround: Use CFS regions if a large number (greater than 512) of application flows need to be configured. CFS regions segment the FCR peer topology into manageable proportions. • CSCtr29423 Symptom: Tape acceleration is not working with the Emulex CNA card. This issue can be seen because the Emulex CNA card uses the same OXID for all fast-path SCSI commands (read/write), which breaks tape acceleration logic for accelerating the read/write IOs. Workaround: None. • CSCtr50223 Symptom: On the MDS 9513 switch, when an MSM-18/4 module boots up, it sends a request to the supervisor module to mount the modflash on the MSM-18/4 module. If there is a timeout or error in response, the following syslog message displays: 2011 Jul 14 01:18:13 sw-dc5-br2-12 %LC_MNT_MGR-SLOT3-2-LC_MNT_MGR_ERROR: SUP mount failed. MTS receive timedout 2011 Jul 14 01:19:06 sw-dc5-br2-12 %PROC_MGR-SLOT3-2-ERR_MSG: ERROR: PID 1144 (lc_mnt_mgr) exited abnormally, exit status (0xa) 2011 Jul 14 01:19:06 sw-dc5-br2-12 %MODULE-2-MOD_MINORSWFAIL: Module 3 (serial: JAE1141ZB43) reported a failure in service lc_mnt_mgr This issue might be seen when the supervisor module is unusually busy and cannot process the mount request from the MSM-18/4 module, or the actual mount command on the supervisor takes a long time. Workaround: Reload the MSM-18/4 module in the same slot/module where the modflash mount failed. A request will be sent to the supervisor to mount the modflash. • CSCtr55608 Symptom: Following the insertion of the 32-port 8-Gbps Advanced Fibre Channel switching module (DSX9232-256K9), the following syslog message is displayed: 2011 Jul 16 05:35:00 emc-9513-II %SYSMGR-STANDBY-3-UNACCEPTABLE_WAIT: Service "r es_mgr", no response from System Manager after 10 seconds. Terminating. This issue might be seen if you enter the no install feature-set fcoe command, then power down the 32-port 8-Gbps Advanced Fibre Channel switching module, and then insert the module again, which triggers the install feature-set fcoe command. Workaround: None. This is a not an operationally impacting issue because it happens on the standby supervisor, and the standby supervisor can successfully come up in spite of the syslog message. Related Documentation The documentation set for NX-OS for the Cisco MDS 9000 Family includes the following documents. To find a document online, access the following web site: http://www.cisco.com/en/US/products/ps5989/tsd_products_support_series_home.html The documentation set for Cisco Fabric Manager appears in the Cisco Fabric Manager Release Notes for Release 4.2(1), which is available from the following website: http://www.cisco.com/en/US/products/ps10495/prod_release_notes_list.html OL-25090-02 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(2) 41