HP Cisco MDS 9216i Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Rel - Page 50
Open Caveats, Symptom, Workaround, Resync Open Fabric, show startup, running-config startup-config
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Caveats Send documentation comments to mdsfeedback-doc.com. • CSCsw48060 Symptom: FCIP interoperability fails between two MDS switches, one running MDS NX-OS Release 4.1(1c) and the other running MDS NX-OS Release 4.1(3a), if the IP ACL configuration for an IPSec crypto map specifies TCP as the protocol, as in the following example: switch(config)# ip access-list acl-name permit tcp local-gige-ip-address local-mask remote-gige-ipaddress remote-mask FCIP interoperability does not fail if the IP ACL uses IP as the protocol, as in the following example: switch(config)# ip access-list acl-name permit ip local-gige-ip-address local-mask remote-gige-ipaddress remote-mask Workaround: This issue is resolved. • CSCsw78035 Symptom: When FlexAttach is enabled on the switch, the physical pWWN in the FCNS registration response is not rewritten with the virtual pWWN. Workaround: This issue is resolved. • CSCsx39090 Symptom: When you click Resync Open Fabric in Fabric Manager, the fabric configuration appears to be saved to the startup configuration, when in fact it is not saved. The same situation occurs when you exit Fabric Manager: the fabric configuration is not saved to the startup configuration. Workaround: This issue is resolved. Open Caveats • CSCsk35725 Symptom: Fabric Manager takes 2 to 3 minutes to bring up the DMM job creation wizard in a setup with 25 switches, 400 enclosures, and 2400 entries in the name server. Workaround: None. • CSCsq20408 Symptom: The show startup command displays aspects of the running configuration when SANtap is configured and/or SANtap objects are created. When a user creates objects such as a CVT or DVT, the configuration is showing in the running-configuration and in the startup-configuration without copying the configuration into the startup-configuration. Workaround: Issue a copy running-config startup-config command whenever you create objects such as a CVT or DVT so that the running-configuration and startup-configuration are synchronized. • CSCsu72195 Symptom: When replaying DMM job configurations saved as an ASCII text file (after performing a write erase), the DMM job includes discrepancies. These discrepancies occur due to the interface and zone configurations that are in an area below the DMM job configuration in the ASCII text file. The configurations stored in the ASCII text file are replayed sequentially from top to bottom. Workaround: None. Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(3a) 50 OL-17675-05