HP Cisco MDS 9222i Cisco MDS 9200 Series Hardware Installation Guide (OL-16188 - Page 118
Installing the Switch on the Shelf Brackets
View all HP Cisco MDS 9222i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Cisco MDS 9000 Family telco and EIA Shelf Bracket Appendix A Cabinet and Rack Installation Step 4 Step 5 Attach the crossbar to the shelf brackets as shown in Figure A-2, using the 10-32 screws. Insert the slider rails into the shelf brackets as shown in Figure A-2. Then, attach them to the rear rack-mounting rails using a minimum of four 12-24 or 10-24 screws. Installing the Switch on the Shelf Brackets This section provides general instructions for installing the switch on top of the shelf brackets. For installation instructions, see the "Installing the Chassis in a Cabinet or Rack" section on page 2-5. Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security. Statement 1017 Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.Statement 1030 Note Before you install, operate, or service the system, refer to the Regulatory Compliance and Safety Information for the Cisco MDS 9000 Family for important safety information. To install the switch on top of the shelf brackets, follow these steps: Step 1 Step 2 Step 3 Ensure that the shelf brackets are level and securely attached to the rack-mounting rails, the crossbar is securely attached to the shelf brackets, and the rack is stabilized. Slide the switch onto the shelf brackets, ensuring it is squarely positioned. Attach the switch to the rack-mounting rails. See the "Installing the Chassis in a Cabinet or Rack" section on page 2-5. Caution We recommend grounding the chassis, even if the rack is already grounded. There is a grounding pad with two threaded M4 holes on the chassis for attaching a grounding lug. Cisco MDS 9200 Series Hardware Installation Guide A-8 OL-16188-01