HP Cisco MDS 9222i Cisco MDS 9200 Series Hardware Installation Guide (OL-16188 - Page 65
Installing the Cisco MDS 9200 Series in the Rack, Step 3
View all HP Cisco MDS 9222i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 2 Installing the Cisco MDS 9200 Series Installing the Chassis in a Cabinet or Rack Step 3 Position the chassis in the rack, inserting the rear of the chassis between the front mounting rails (see Figure 2-4). Use the 12-24 x 3/4-in. or 10-32 x 3/4-in. screws (depending on the type of rack) to attach the front rack-mount brackets to the mounting rails (three per side). If you are installing the optional cable guides, place the cable guides in front of the front rack-mount brackets, and then pass the screws through the cable guides, front rack-mount brackets, and mounting rail. You can install one or both cable guides; if installing a single cable guide, it can be installed on either side. Figure 2-4 Installing the Cisco MDS 9200 Series in the Rack 1 3 1 2 MDS 9216i 3 4 5 6 7 8 9 10 11 12 13 14 LINK GE1 LINK GE2 116893 2 1 Mounting rail 2 Front rack-mount bracket 3 Screws, 12-24 or 10-32 Step 4 Step 5 From the back of the rack, position the longer slider rails with the ears away from the chassis and slide them into the C brackets previously installed on the sides of the chassis (see Figure 2-5). Level the chassis (it may sag slightly towards the back) and attach the slider rails to the mounting rails with the 12-24 x 3/4-in. or 10-32 x 3/4-in. screws, three per side. OL-16188-01 Cisco MDS 9200 Series Hardware Installation Guide 2-9