HP ENVY 14-3090ca HP ENVY14 SPECTRE Maintenance and Service Guide IMPORTANT! T - Page 48
from the TouchPad., Release the ZIF connector to which the TouchPad cable is connected
View all HP ENVY 14-3090ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
NOTE: When replacing the top cover, be sure to remove the following components from the defective top cover and install them on the replacement top cover: ● NFC board (see NFC board on page 37) ● Solid-state drive connector board (see Card Reader board cable on page 36) ● Card Reader board (see Card Reader board on page 44) ● Power button board (see Power button board on page 45) Remove the top cover: 1. Release the ZIF connector to which the TouchPad cable is connected, and then disconnect the TouchPad cable (1) from the TouchPad. 2. Disconnect the speaker cable (2) from the system board. 3. Remove the two rear rubber feet (1). 40 Chapter 4 Removal and replacement procedures
NOTE:
When replacing the top cover, be sure to remove the following components from the defective
top cover and install them on the replacement top cover:
●
NFC board (see
NFC board
on page
37
)
●
Solid-state drive connector board (see
Card Reader board cable
on page
36
)
●
Card Reader board (see
Card Reader board
on page
44
)
●
Power button board (see
Power button board
on page
45
)
Remove the top cover:
1.
Release the ZIF connector to which the TouchPad cable is connected, and then disconnect
the TouchPad cable
(1)
from the TouchPad.
2.
Disconnect the speaker cable
(2)
from the system board.
3.
Remove the two rear rubber feet
(1)
.
40
Chapter 4
Removal and replacement procedures