HP ENVY 15-k200 Maintenance and Service Guide 1 - Page 59

The power connector cover has two screws, however, the screw on the left is removed during

Get HP ENVY 15-k200 PDF manuals and user guides View all HP ENVY 15-k200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

3. On the right side, disconnect the WLAN cable (3) and carefully remove the cable from the retaining tabs (4). 4. Remove the power connector cover by removing the Phillips screw (1) and lifting the cover (2). NOTE: The power connector cover has two screws, however, the screw on the left is removed during the base enclosure and top cover removal process. Removing the cover is required for the display panel removal. NOTE: You will remove the power connector after you have removed the system board. This procedure is to remove the power connector cover. Component replacement procedures 49

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
3.
On the right side, disconnect the WLAN cable
(3)
and carefully remove the cable from the retaining tabs
(4)
.
4.
Remove the power connector cover by removing the Phillips screw
(1)
and lifting the cover
(2)
.
NOTE:
The power connector cover has two screws, however, the screw on the left is removed during
the base enclosure and top cover removal process. Removing the cover is required for the display panel
removal.
NOTE:
You will remove the power connector after you have removed the system board. This
procedure is to remove the power connector cover.
Component replacement procedures
49