HP ENVY 17-j092nr HP ENVY 17 Notebook PC HP ENVY TouchSmart m7 Notebook PC HP - Page 64
Remove the Phillips PM screws, sleeves must be installed on the antenna connectors.
View all HP ENVY 17-j092nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
2. Remove the Phillips PM screws (2) that secure the WLAN module to the system board. (The WLAN module tilts up.) 3. Remove the WLAN module by pulling the module away from the slot at an angle (3). NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the protective sleeves must be installed on the antenna connectors. 54 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
2.
Remove the Phillips PM screws
(2)
that secure the WLAN module to the system board. (The WLAN
module tilts up.)
3.
Remove the WLAN module by pulling the module away from the slot at an angle
(3)
.
NOTE:
If the WLAN antennas are not connected to the terminals on the WLAN module, the protective
sleeves must be installed on the antenna connectors.
54
Chapter 5
Removal and replacement procedures for Customer Self-Repair parts