HP ENVY 17t-3000 HP ENVY 17 - Maintenance and Service Guide - Page 72
Card Reader board, Remove the Card Reader board
View all HP ENVY 17t-3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Card Reader board Description For use only on computer models with USB 3.0 capability For use only on computer models with USB 2.0 capability Spare part number 689995-001 665923-001 Before removing the Card Reader board, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 39), and then remove the following components: a. Subwoofer (see Subwoofer on page 41) b. Hard drive (see Hard drive on page 51) c. Top Cover (see Top cover on page 56) Remove the Card Reader board: 1. Release the Card Reader board cable (1) from the base enclosure. (The Card Reader board cable is attached to the base enclosure with double-sided tape.) 2. Disconnect the Card Reader board cable (2) from the system board. 3. Remove the three Phillips PM2.5×4.5 screws (3) that secure the Card Reader board to the base enclosure. 64 Chapter 4 Removal and replacement procedures ENWW