HP EVA P6550 HP P6000 Enterprise Virtual Array release notes (XCS 10001000) (5 - Page 11
SAN support, Supported Fibre Channel switches, Supported disks, Performance sizing - storage eva
View all HP EVA P6550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
NOTE: For the EVA4400, HP Command View EVA 9.2 is pre-installed on the controller enclosure management module (for array-based management); on the P6300/P6500 EVA, HP P6000 Command View 9.4 is pre-installed. You can still use HP P6000 SmartStart to configure application servers. To bypass the HP P6000 SmartStart interface and manually run the HP P6000 Command View installer, go to the \bin\installers\CV directory on the CD. HP P6000 SmartStart will install HP MPIO EVA DSM, which enables you to provision storage from the array; and DSM Manager, which enables you to change the default settings of HP MPIO EVA DSM. For more information about HP P6000 SmartStart, see the latest product release notes, which are available at: http://www.hp.com/support/manuals Under storage, select Storage Software. Then, select HP P6000 SmartStart under Storage Device Management Software. SAN support The HSV300 controller in the EVA4400 supports 2/4 Gb Fibre Channel communication, but requires 4 Gb SFPs in the controller host ports. The HSV300-S supports up to 8 Gb communication through the embedded switch ports. The HSV400 controller in the EVA6400 and the HSV450 controller in the EVA8400 are enabled for 4 Gb/s on each Fibre Channel host path, but will also support 2 Gb/s Fibre Channel host paths and components for backward compatibility. NOTE: 1 Gb path and components have specific configuration requirements. For more information on configuration requirements and support for 2 Gb and 4 Gb EVAs, see the HP SAN Design Reference Guide, which can be downloaded from the following website: http://www.hp.com/support/manuals Click Storage Networking under Storage, and then select HP SAN under HP SAN Solutions. Supported Fibre Channel switches For complete information on which Fibre Channel switches are supported, see the Single Point of Connectivity Knowledge (SPOCK) at: http://www.hp.com/support/manuals. You must log in to access SPOCK. If you do not already have an account, select Register to log in on the main page and follow the instructions. Supported disks For information about disk drive support, see HP P6000 Enterprise Virtual Array Disk Drive Firmware Support, available on the HP Manuals website: http://www.hp.com/support/manuals. Under storage, click Disk Storage Systems, and then select the appropriate array model under P6000/EVA Disk Arrays. Performance sizing To configure your array for the intended disk model(s) and host I/O workloads, please contact your HP account support representative for consulting services and instructions. For additional information on performance and solutions, see the following HP websites: • http://h18006.www1.hp.com/storage/arraywhitepapers.html • http://h18006.www1.hp.com/storage/whitepapers.html SAN support 11