HP EliteDisplay E243m User Guide - Page 30

Using the auto-adjustment function (analog input), Image Control > Auto Adjustment

Get HP EliteDisplay E243m PDF manuals and user guides View all HP EliteDisplay E243m manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Using the auto-adjustment function (analog input) When you first set up the monitor, conduct a Factory Reset of the computer, or change the resolution of the monitor, the Auto-Adjustment feature automatically engages, and attempts to optimize your screen for you. You may also optimize the screen performance for the VGA (analog) input at any time from the Auto Adjustment menu in the OSD and by using the auto-adjustment pattern software utility on the optical disc provided (select models only). Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions: ● Fuzzy or unclear focus ● Ghosting, streaking, or shadowing effects ● Faint vertical bars ● Thin, horizontal scrolling lines ● An off-center picture To use the auto-adjustment feature: 1. Allow the monitor to warm up for 20 minutes before adjusting. 2. Press the Menu button, and then select Image Control > Auto Adjustment from the OSD menu. If the result is not satisfactory, continue with the procedure. 3. Select Open Auto-Adjustment Utility provided on the optical disc, if one is included with your monitor. The setup test pattern is displayed. 4. Press the ESC key or any other key on the keyboard to exit the test pattern. NOTE: The auto-adjustment test pattern utility can be downloaded from http://www.hp.com/support. 24 Chapter 3 Support and troubleshooting

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
Using the auto-adjustment function (analog input)
When you
first
set up the monitor, conduct a Factory Reset of the computer, or change the resolution of the
monitor, the Auto-Adjustment feature automatically engages, and attempts to optimize your screen for you.
You may also optimize the screen performance for the VGA (analog) input at any time from the Auto
Adjustment menu in the OSD and by using the auto-adjustment pattern software utility on the optical disc
provided (select models only).
Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a VGA
(analog) input, this procedure can correct the following image quality conditions:
●
Fuzzy or unclear focus
●
Ghosting, streaking, or shadowing
effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An
off-center
picture
To use the auto-adjustment feature:
1.
Allow the monitor to warm up for 20 minutes before adjusting.
2.
Press the
Menu
button, and then select
Image Control > Auto Adjustment
from the OSD menu. If the
result is not satisfactory, continue with the procedure.
3.
Select
Open Auto-Adjustment Utility
provided on the optical disc, if one is included with your monitor.
The setup test pattern is displayed.
4.
Press the
ESC
key or any other key on the keyboard to exit the test pattern.
NOTE:
The auto-adjustment test pattern utility can be downloaded from
support
.
24
Chapter 3
Support and troubleshooting