HP G60-231WM Service Guide - Page 74
and then remove the actuator
View all HP G60-231WM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
6. Remove the four Phillips PM2.0x4.0 screws 1 that secure the TouchPad board to the base enclosure. Then remove the TouchPad board and bracket 2. 7. Remove the two Phillips PM2.0x4.0 screws 1 that secure the switch actuator to the TouchPad board bracket, and then remove the actuator 2. ✎ The TouchPad is glued to the top cover and is included with the top cover spare part. Reverse this procedure to install the TouchPad on/off button board and board bracket. Removal and replacement procedures 4-33
Removal and replacement procedures
4–33
6. Remove the four Phillips PM2.0x4.0 screws
1
that secure the TouchPad board to the base enclosure. Then
remove the TouchPad board and bracket
2
.
7. Remove the two Phillips PM2.0x4.0 screws
1
that secure the switch actuator to the TouchPad board bracket,
and then remove the actuator
2
.
✎
The TouchPad is glued to the top cover and is included with the top cover spare part.
Reverse this procedure to install the TouchPad on/off button board and board bracket.