HP Indigo 10000 B&R Drive Replacement -- CA493-00640 Rev 00 - Page 6

Safety procedure for replacing the B&R main motor drive or motor

Get HP Indigo 10000 PDF manuals and user guides View all HP Indigo 10000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

9. Reinstall the cover. 10. Turn on the press. Turn on the press software. 11. Wait 15 minutes for the firmware to finish updating automatically. 12. If the B&R drive is for the main motor (or you replaced the main motor itself), do the next procedure. Safety procedure for replacing the B&R main motor drive or motor After the new drive (or the main motor itself) is installed, do the following: 1. Access the power distribution unit (PDU). 2. Look at the safety programmable logic controller (SLC) status LEDs. Figure 2-4 SLC status LEDs 3. Make sure that the module exchange (MXCHG) LED blinks orange once every few seconds. 4. Turn the selection switch to 1. 5. Press the ENTER button for 2 seconds. The SLC reboots and registers the new drive. 6. Make sure that the R/E LED is lit up in green. (This means the the SLC in "run" mode). 4 Chapter 2 Procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
9.
Reinstall the cover.
10.
Turn on the press. Turn on the press software.
11.
Wait 15 minutes for the firmware to finish updating automatically.
12.
If the B&R drive is for the main motor (or you replaced the main motor itself), do the next procedure.
Safety procedure for replacing the B&R main motor drive or motor
After the new drive (or the main motor itself) is installed, do the following:
1.
Access the power distribution unit (PDU).
2.
Look at the safety programmable logic controller (SLC) status LEDs.
Figure 2-4
SLC status LEDs
3.
Make sure that the module exchange (MXCHG) LED blinks orange once every few seconds.
4.
Turn the selection switch to 1.
5.
Press the ENTER button for 2 seconds. The SLC reboots and registers the new drive.
6.
Make sure that the R/E LED is lit up in green. (This means the the SLC in “run” mode).
4
Chapter 2
Procedures