HP Indigo W7250 Charge Roller -- CA393-00080 Rev 07 - Page 9

Connect the solenoid connector.

Get HP Indigo W7250 PDF manuals and user guides View all HP Indigo W7250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

2. Using a small Phillips screwdriver, remove the three screws attached to the solenoid connector cover. Remove the cover. Figure 1-9 Phillips screws attaching the rear solenoid connector cover 3. Disconnect the solenoid connector, Figure 1-10 Rear solenoid connector 4. Remove the solenoid assembly. Figure 1-11 Removing the rear solenoid 5. Install the new solenoid assembly into position. 6. Connect the solenoid connector. 7. Install the solenoid connector cover. Use the three Phillips screws to fasten it to the charge roller assembly. Replacing the rear solenoid 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
2.
Using a small Phillips screwdriver, remove the three screws attached to the solenoid connector cover.
Remove the cover.
Figure 1-9
Phillips screws attaching the rear solenoid connector cover
3.
Disconnect the solenoid connector,
Figure 1-10
Rear solenoid connector
4.
Remove the solenoid assembly.
Figure 1-11
Removing the rear solenoid
5.
Install the new solenoid assembly into position.
6.
Connect the solenoid connector.
7.
Install the solenoid connector cover. Use the three Phillips screws to fasten it to the charge roller
assembly.
Replacing the rear solenoid
7