HP Indigo WS6600 Long Term Shutdown for Indigo WS6000 Series Digital Presses a - Page 6

Restarting the press after a long period,

Get HP Indigo WS6600 PDF manuals and user guides View all HP Indigo WS6600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

28. Shut down and disconnect the UPS. Disconnect its internal battery. Figure 2-1 UPS 1 UPS front view 2 UPS back view - remove this cover 3 Disconnect the internal battery 29. Use air pressure the clean the Amatek air filter. 30. Inspect the electrical cabinet: a. Using a vacuum cleaner, clean the electrical cabinet and around the press. NOTE: Do not blow air. This can cause dust to get into the Digitax and remain there. This can damage the Digitax. b. Clean all Digitax units from dust. c. If necessary, clean electronics cabinet door filters. 31. Turn off the air pressure. Clean the air filter. 32. Inform your Team Leader and HP Indigo that the press has been shutdown for a long period. Restarting the press after a long period Follow the below steps to restart the press after a long period: 1. Reconnect the UPS internal battery (see Shutting down the press before a long period on page 2). Turn on the UPS. 2. If the press was shut down for more than one month, it is recommended to replace the UPS battery with a new one. 3. Check the imaging oil flow. (If it is too low, the heat exchanger may be clogged and need to be replaced. Use Print Care to troubleshoot this issue.) 4. Connect all of the cooling pipes and valves. Check for leaks. 5. Install the ink tanks. 4 Chapter 2 Procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
28.
Shut down and disconnect the UPS. Disconnect its internal battery.
Figure 2-1
UPS
1
UPS front view
2
UPS back view - remove this cover
3
Disconnect the internal battery
29.
Use air pressure the clean the Amatek air filter.
30.
Inspect the electrical cabinet:
a.
Using a vacuum cleaner, clean the electrical cabinet and around the press.
NOTE:
Do not blow air. This can cause dust to get into the Digitax and remain there. This can
damage the Digitax.
b.
Clean all Digitax units from dust.
c.
If necessary, clean electronics cabinet door filters.
31.
Turn off the air pressure. Clean the air filter.
32.
Inform your Team Leader and HP Indigo that the press has been shutdown for a long period.
Restarting the press after a long period
Follow the below steps to restart the press after a long period:
1.
Reconnect the UPS internal battery (see
Shutting down the press before a long period
on page
2
).
Turn on the UPS.
2.
If the press was shut down for more than one month, it is recommended to replace the UPS battery
with a new one.
3.
Check the imaging oil flow. (If it is too low, the heat exchanger may be clogged and need to be
replaced. Use Print Care to troubleshoot this issue.)
4.
Connect all of the cooling pipes and valves. Check for leaks.
5.
Install the ink tanks.
4
Chapter 2
Procedures