HP J6039C HP Jetdirect 200m Print Server - (English) Administrator Guide - Page 90
Table 3.4, Telnet Commands and Parameters 10 of 18, TCP/IP Configuration 90
UPC - 829160056487
View all HP J6039C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Table 3.4 Telnet Commands and Parameters (10 of 18) syslog-max Specifies the maximum number of syslog messages that can be sent by the HP Jetdirect print server on a per-minute basis. This setting allows administrators to control the log file size. The default is 10 per minute. If it's set to zero, the number of syslog messages is not restricted. syslog-priority Controls the filtering of syslog messages sent to the syslog server. The filter range is 0 to 8, with 0 being the most specific and 8 the most general. Only messages that are lower than the filter level specified (or higher in priority) are reported. The default setting is 8, where messages of all priorities are sent. If 0, all syslog messages are disabled. syslog-facility A code used to identify the source facility of a message (for example, to identify the source of selected messages during troubleshooting). By default, the HP Jetdirect print server uses LPR as the source facility code, but local user values of local0 through local7 can be used to isolate individual or groups of print servers. slp-config Enables or disables the Service Location Protocol (SLP) operation on the print server: 0 disables, 1 (default) enables. SLP is used by selected HP software applications (through UDP port 427) to automate device discovery. mdns-config Enables or disables Multicast Domain Name System (mDNS) services. 0 disables, 1 (default) enables. mDNS is typically used on small networks for IP address and name resolution (through UDP port 5353) where a conventional DNS server is not available. mdns-service-name Specifies an alphanumeric string of up to 64 ASCII characters assigned to this device or service. This name is persistent and is used to resolve a particular device or service if socket information (such as the IP address) changes from session to session. Apple Rendezvous will display this service. The default service name is the printer model and the LAN Hardware (MAC) address. mDNS Domain Name (Read-only parameter) Specifies the mDNS domain name assigned to the device, in the form .local. If a user-specifed host name has not been assigned, the default host name NPIxxxxxx is used, where xxxxxx are the last 6 digits of the LAN hardware (MAC) address. ENWW TCP/IP Configuration 90