HP Kayak XA-s 02xx HP Kayak XA-s, XU, and XW PC Workstations - Familiarization - Page 36

Answers and Explanations Answers and Explanations 1 Can a 256 MB registered ECC memory module be mixed with a non-buffered ECC SDRAM memory module? b No, it cannot. Registered and non-buffered memory modules are not compatible. 2 Can a maximum of 512 MB of non-buffered ECC SDRAM memory modules be installed on HP Kayak XA-s, XU, and XW Series U3 and W3 PC Workstations? b No. On the HP Kayak XA-s, there are only three DIMM sockets available. 3 For models with the HP FastRAID2 I/O Subsystem, can you boot from the Windows NT CD-ROM when replacing a disk drive? b No, because the new hard drive will not be found. 4 Where can you find all of the HP FastRAID software (ArrayConfig, drivers and CI/O Manager) and Operating System Installation notes (such as Windows NT 4.0)? a & b The HP Kayak XU/XW PC Workstation Drivers CD-ROM contains this software. The most recent updates may be obtained from the HP WWW site. 5 To run the MaxiLife diagnostics program, does the computer need to be powered on? b No, it doesn't. The HP MaxiLife is always running and continuously monitors the state of the LCD buttons. (The power cable must always be connected.) 6 Can the Internal SCSI 16 Bits (Adaptec) and External/Internal 16/8 Bits (Symbios) options be set to enabled at the same time? b No, these two utilities cannot be loaded at the same time. c This is not possible on HP Kayak XA-s PC Workstations. 36