HP Kayak XU 03xx HP Kayak XU Series 03xx, Setting Up And Using Your PC Worksta - Page 5

HP Kayak XU 03xx PC Workstation - Setting Up and Using Your HP PC Workstation Connecting an External SCSI Accessory Connecting an External SCSI Accessory Your PC Workstation is equipped with an UltraWide 16-bit SCSI connector for external SCSI devices. When an external SCSI device is connected, the UltraWide 16-bit SCSI controller automatically switches to non-Ultra mode (maximum capacity of 20 MBs per second). An external SCSI device is connected as follows: 1 You should assign an unused SCSI address to the accessory. SCSI addresses range from 0 to 15 for wide 16-bit SCSI. The SCSI address 0 is reserved for the first SCSI hard disk drive and SCSI address 7 is reserved for SCSI controller (the default for narrow and wide SCSI devices). Refer to the manual provided with the SCSI accessory for instructions on selecting a SCSI address. NOTE You don't need to set a SCSI address for Plug and Play SCSI devices (SCSI devices which support the SCAM protocol). 2 Make sure the SCSI accessory is terminated correctly-either internally or by a terminating resistor (refer to the manual provided with the SCSI accessory). Make sure the SCSI accessory is terminated English 5