HP Kayak XW 04xx HP Kayak XW Series 0480, Accessories Installation Guide - Page 14

HP Kayak XW 0480 PC Workstation - Installing Accessories In Your HP PC Workstation Installing Mass Storage Devices Completing the Installation of a Hard Disk Drive When a SCSI Hard Disk Drive Is Installed For more information on completing the installation of a SCSI hard disk drive, refer to the SCSI Administrator's Guide available on HP's web site at http://www.hp.com/go/kayaksupport. When an IDE Drive Is Installed 1 Switch on the computer. 2 To display the device in POST, press re-starts. while the PC Workstation 3 If an error message appears, follow the instructions provided by the Error Message Utility. When prompted, press to run the Setup program. 4 Select the Advanced menu, and the IDE Devices submenu. In the IDE Primary Master item, check that the details for the device have been correctly detected by the Setup program. 5 Press to save and exit Setup. Refer to the operating system documentation for information on formatting a drive. NOTE If an IDE drive is removed, the system BIOS will automatically detect that the device is missing. Press to confirm that you want to remove the device. The system configuration will be updated automatically. Before Installing an IDE Device Installing a Drive in a Front-Access Shelf These instructions explain how to install a drive (such as a flexible disk drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the front-access drive shelves. You should also refer to the manual supplied with the drive for any additional installation instructions. Refer to the drive's installation guide to see if you must set jumpers or if there is a special installation procedure to follow. 14 English