HP L1530 User's Guide L1530 and L1730 Flat Panel Monitors - Page 32

Problem, Possible Cause, Solution, Troubleshooting, User's Guide - resolution

Get HP L1530 - LCD Flat Panel Monitor PDF manuals and user guides View all HP L1530 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Troubleshooting Problem Possible Cause Solution Image appears blurred, Brightness and contrast are Press the Minus button on the indistinct, or too dark. too low. monitor front panel to auto- adjust the screen. If that doesn't work, press the Menu button to open the Basic OSD Menu, and adjust the brightness and contrast scales as needed. Image is not centered. Position may need adjustment. When OSD is inactive, press (minus button) to auto-adjust the screen image. Press the Menu button to access the Advanced OSD menu. Select Image Control/Horizontal Position or Vertical Position to adjust the horizontal or vertical position of the image. "Check Video Cable" Monitor video cable is is displayed on screen. disconnected. Connect the 15-pin monitor video cable to the VGA connector on the computer. Be sure that the computer power is off while connecting the video cable. "Input Signal Out of Video resolution and/or Restart your computer and Range" is displayed on refresh rate are set higher enter Windows Safe Mode by screen. than what your monitor pressing the F6 Function key supports. when the computer starts to boot up. Change your settings to a supported setting. Restart your computer so that the new settings take effect. A-2 User's Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
Troubleshooting
Problem
Possible Cause
Solution
Image appears blurred,
indistinct, or too dark.
Brightness and contrast are
too low.
Press the Minus button on the
monitor front panel to auto-
adjust the screen. If that
doesn’t work, press the Menu
button to open the Basic OSD
Menu, and adjust the
brightness and contrast scales
as needed.
Image is not centered. Position may need
adjustment.
When OSD is inactive, press
(minus button) to auto-adjust
the screen image.
Press the Menu button to
access the Advanced OSD
menu. Select Image
Control/Horizontal Position or
Vertical Position to adjust the
horizontal or vertical position
of the image.
“Check Video Cable”
is displayed on screen.
Monitor video cable is
disconnected.
Connect the 15-pin monitor
video cable to the VGA
connector on the computer. Be
sure that the computer power
is off while connecting the
video cable.
“Input Signal Out of
Range” is displayed on
screen.
Video resolution and/or
refresh rate are set higher
than what your monitor
supports.
Restart your computer and
enter Windows Safe Mode by
pressing the F6 Function key
when the computer starts to
boot up. Change your settings
to a supported setting. Restart
your computer so that the new
settings take effect.
A-2
User’s Guide