HP LE1851w HP LE1851w, LE2001w, and LE2001wm LCD Monitors - Page 17
Mounting the Monitor Panel
View all HP LE1851w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Mounting the Monitor Panel You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm, or other mounting fixture. Four threaded mounting holes are provided on the monitor back panel to be used for mounting purposes. NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket. CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. 1. Disconnect and remove the signal and power cables from the back of the monitor. 2. Lay the monitor face down on a flat surface. 3. Remove the four screws on the back of the monitor that connect the monitor panel to the pedestal base (1) and slide the pedestal base from the monitor panel (2). Figure 3-7 Removing the Pedestal Base ENWW Mounting the Monitor Panel 9