HP LH4r HP Netserver LC 2000 Internal to External SCSI Cable Kit - Page 1
HP LH4r - NetServer - 256 MB RAM Manual
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installing the HP NetServer LC 2000 Internal to External SCSI Cable Kit The HP NetServer LC 2000 can be configured to extend one of its SCSI channels (typically channel B) to an external Wide SCSI connector. This allows you to connect additional external mass storage devices to the second channel of the system's embedded SCSI controller. It requires a second external SCSI cable to connect the HP NetServer to the external SCSI device. 1. To install the external SCSI cable, connect one end to the free SCSI connector on the system board (refer to the Technical Reference Card on the chassis for location). 2. Using a flat blade screwdriver, pop out the external SCSI knock-out at the rear of the system (see Figure 2 for location). 3. Thread the cable from the SCSI channel B connector to the cutout at the rear of the chassis (see Figure 2). IDE CD-ROM SCSI B SCSI A Flexible Disk Drive 1 2 3 45 6 Slots P1-4 32-bit 33 MHz Slots P5-6 64-bit 33 MHz Figure 1. Location of Internal SCSI Connectors 4. Install the external connector end of the cable to the rear where the knockout was removed and insert the two threaded studs from the outside (see Figure 2). HP Part Number 5971-0812 Printed in October 2000 '"&$( %'