HP LH4r HP Netserver LC 2000r Rack Cabling Reference Guide - Page 47

Chapter 3 Procedure for Connecting and Routing Cables to the LC 2000r accompanying power cord to the PDU and attach the C20 end of the same cord to the IEC 320 receptacle in the rear of the UPS. Alternate 230/240 VAC Power Configuration When the 230/240 VAC PDU is to be used without a UPS in the rack, the PDU is shipped with a localized power cord. NOTE Only localized power cords rated 16A will allow the full 16A rating of the PDU to be used. For use with 230/240 VAC power mains, direct connection to a junction box is usually necessary. In this case, an unterminated power cord is supplied. Be sure to obey all local electrical code requirements when connecting to the site electrical power supply. Table 3-3. 230/240 VAC PDU Power and Current Component1 Model 200/240 VAC PDU HP NetServer LC 2000r E7671A or E7672A D8515A, 533 MHz, 128 MB D8520A, 600 MHz, 128 MB D8525A, 667 MHz, 128 MB Power (VA) N/A Power (W) N/A Current (A)2 max 16 514 504 2.3 HP NetServer Rack Storage/12 is D5989A 518 507 2.3 Mass Storage Rack Storage/12FC is D5991A Unit HP Console Switch J1497B 42 29 0.2 Note 1 More ratings are listed in Table 2-9. For a full list of power ratings, see the rack configuration utilities (for instance, Rack Assistant) on the HP Web Site. Note 2 Indicated current ratings are for use in selecting PDU and UPS components and may not reflect actual measured amounts. Description of the Recommended 230/240 VAC Configuration Figure 3-5 shows a UPS connected to the power mains through an attached power cord (appropriate cords are supplied for each country). The UPS has eight IEC 320 receptacles for use with the rack jumper cords. The E7671A PDU connects to the UPS via a detachable line cord, which connects to the PDU via a C-19 plug. This cord connects to the UPS with a C-20 plug. The 200/240 VAC PDU has two 43