HP LH4r HP Netserver LC II Installation Roadmap - Page 2
Overview of HP NetServer LC II Features, Verify Contents - lan server
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
LC II Installation Road Map Table of Contents 1.Overview of HP NetServer LC II Features 2. Verify Contents 3. Obtain HP Navigator CD-ROM Release History 4. Connect Monitor, Keyboard, and Mouse 5. Prepare for Installation 6. Remove the Covers 7. Install Additional Memory 8. Install All Accessory Boards 9. Install Additional Mass Storage Devices 10. Replace All Covers and Connect All Cables 11. Verify Installed Accessories (Optional) 12. Configure the HP NetServer 13. Install in Rack (Optional) Audience Assumptions This road map is intended for the person who installs, administers, and troubleshoots LAN servers. Hewlett-Packard Company assumes that you are qualified in the servicing of computer equipment and trained in recognizing hazards in products with hazardous energy levels. ESD Warning This HP NetServer contains sensitive electronic devices that can be damaged by electrostatic discharge (ESD). ESD hazards are a result of installation or service personnel failing to ground themselves properly. To be properly grounded, you must use a proper ESD wrist strap and work surface grounded to the HP NetServer chassis. 1 Overview of HP NetServer LC II Features Power Switch and Power LED Keyboard Lock Switch and Keyboard Lock LED Front Bezel Front Bezel Key Lock Locked Position Unlocked Position Shelf 1 (Flexible Disk Drive) Serial Number Shelf 2 (CD-ROM Drive) Shelf 3 Shelf 4 Shelf 5 Shelf 6 Pedestal Shelf 3 Hot Swap Subsystem Lock on Locking Bar Front View with Mass Storage Shelves CPU CPU Extractor Handle System Board Front View with Hot Swap Subsystem Rear View Retaining Latch Voltage Regulator Module Retaining Latch CPU System Board Serial B Port Serial A Port Parallel Port Mouse Port Keyboard Port Monitor Port Management Port for remote console management using Integrated Remote Assistant Network Connector Power Connector System Switches Connector for External Battery (Hidden) Battery Backplane Power Supply Module Terminator Board Front Bezel and Covers Removed Backplane Slot 1 Network Interface Controller Board (Slot 6) Disk Array Controller Board (Optional, Slot 5) SCSI Connector Flexible Disk Drive (FDD) Connector Interior View 2 Verify Contents 1. Unpack and verify the contents of the shipping box against the Contents Checklist included with your HP NetServer. If anything is missing or damaged, contact your reseller. 2. Mount the HP NetServer on the anti-tip pedestal unless you plan to install it in a rack assembly. The instructions molded into the pedestal point toward the front of the pedestal, which holds the front of the HP NetServer. Center the HP NetServer on the centerline of the pedestal with the front of the HP NetServer extending 2 inches (5 cm) beyond the front of the pedestal. Then push the HP NetServer in toward the rear of the pedestal until it locks into place. NOTE If you plan to install the HP NetServer in a rack assembly, wait to do that in Section 13: "Install in Rack (Optional)" after all options are installed. Refer now to the HP NetServer Rack Installation Road Map to determine whether to configure the HP NetServer before or after you install it in the rack assembly. Also refer to the rack installation kit instructions. Pedestal