HP LH4r HP Netserver LH 6000 Rack Cabling Guide - Page 35
Procedure for Connecting and, Routing Cables to the LH 6000r
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
3 Procedure for Connecting and Routing Cables to the LH 6000r Step 1: Prepare to Cable the HP NetServer LH 6000r Assess How Components Will be Connected to the Server You may find the following steps to be helpful before you begin cabling: • Review the layout of the rack installation generated with Hewlett-Packard rack configuration tools, such as Rack Assistant (available at www.hp.com/go/netservers). • Consider the cabling guidelines discussed in Chapter 2 of this Reference Guide, in the section "Data Cabling References and Guidelines." • Review the plan for your rack power subsystem, considering how you will provide failure resistance (see Appendix B on the Redundant Switch), interim power (see Table 2-1 on Uninterruptible Power Supplies) and distribution (see the section of Chapter 2 titled "Power Distribution Units"). Check that you have completed the mounting of the Cable Guides, Cable Management Arms, and Power Distribution Units as noted below. See Figure 2-2 for an example illustration showing how these three items may look when mounted. Attach Cable Guide to Rack Column Using the instructions included, attach the two Cable Guides to the rack column. Mount the Cable Management Arm The HP NetServer LH 6000r includes a Cable Management Arm. Mount the arm by following the instructions in the HP NetServer LH 6000/6000r Installation Guide which accompanies your unit. Cable routing details are included in the section of this chapter titled "Cable Management." 31