HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) Installation Sheet - Page 5
Post Rack Installation, Post Rack Installation Continued, Post Rack Installation
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
2-Post Rack Installation NOTE ) Refer to the white paper, HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r) on HP's Web site for high-density rack information. NOTE ) The installed inner-rails shipped with the HP Netserver are used for the 4-post HP racks. These rails must be removed for 2-post rack installation and replaced with the mounting brackets. WARNING) To prevent personal injury or damage to the equipment, use two people to mount the HP Netserver into the rack. The HP Netserver weighs 32 lbs (14.5 kg) fully loaded. 2-Post Rack Installation (Continued) Flush Mounting Optional (2) Flush Mount Brackets Only Center Mount Brackets Only Center Mounting 4-Post Rack Installation NOTE) ) WARNING) Refer to the white paper, HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r) on HP's Web site for high-density rack information. To prevent rack instability while mounting the HP Netserver ensure the rack's anti-tip foot is pulled forward out of the bottom. Failure to do so could result in injury and equipment damage. To prevent the rack from rolling while you mount the HP Netserver, ensure the leveler screws on the rack's lower four corners are in firm contact with the floor. Release Spring Assembly 3/4 Counter Clockwise 1/4 Clockwise