HP LH4r HP Netserver LP 2000r FC Config Guide for Windows 2000 Advanced Serve - Page 2

Intra-cluster (Heartbeat) LAN Power source System software: Navigator version Operating System Service Pack SPU Model Clock speed No. of CPUs BIOS version CPU cache RAM Local storage I/O slots Default Boot Order Microsoft® and HP Certified Configuration Embedded NIC with crossover cable, or, configure as a VLAN through an Ethernet switch. See Intra-cluster LAN below. Direct from power mains, power conditioner or uninterruptible power supply (UPS) using any power conditioner or UPS. Redundant power distribution units (PDU's) are strongly recommended. L.20.00 or later Microsoft Windows® 2000 Advanced Server SP1 or later HP NetServer LP2000r 1 GHz 2 4.06.16 or later Any size 256 MB minimum. Must be HP. See Local Storage below. Added cards may be installed in any appropriate slot, keeping in mind the server's default boot order as listed below: IDE CD-ROM, FDD, PCI-1, PCI-2, PCI-3, Embedded SCSI P1 - Local storage (NetRAID-1M) P2 - Shared Storage FC HBA (D8602B) Booted from NetRAID-1M Storage Local Controller Driver Cabinets (Physical drive location) Disk drives SCSI bus SCSI Ids Shared May use embedded SCSI, NetRAID-1Si, NetRAID-3Si, NetRAID-1M, or NetRAID-2M For SPOFless, recommend NetRAID-xM with internal drives in RAID5, or another fault-tolerant RAID level. For embedded SCSI, use SYM_U3.SYS, version 5.07.00 or later. For NetRAID-xSi, use MRAID35X.SYS, version 2.66 or later. For NetRAID-xM, use MRAID2K.SYS version 5.20 (Navigator L.20.00 or later) SPU internal drive bays or HP external drive cabinet (e.g., HP Rack Storage/12), any number. Must be HP (hot swap or fixed). Any HP cables that meet SCSI specifications and any SCSI bus speed. Any HP Rack Storage/12FC Required - D5991A Host Bus Adapter Model No. of controllers Driver HP Fibre Channel Host Bus Adapter - HP D8602B 1 HP D8602B - AFCW2K.SYS 3.0.3245.1 2