HP LH4r hp netserver lp 2000r netraid-2m config guide — for Micro - Page 2

lp2000rnt2m Server Configuration Parameter Number of power supplies I/O slots Default boot order Local Storage Controller Driver Physical drive location Disk drives SCSI bus SCSI IDs System software Navigator CD-ROM Operating system Service pack Power distribution Layout Specification One standard, two required for redundancy Note that in configurations with more than one NetRAID controller, fully populated PCI or hard drive slots, the second power supply is required, and not redundant. Added cards may be installed in any appropriate slot, considering the server default boot order provided below. IDE CD-ROM, FDD, PCI slot 1, PCI slot 2, PCI slot 3, embedded SCSI Embedded SCSI, or NetRAID-1M For embedded SCSI, sym_u3.sys, version 5.05.00, or later For NetRAID-1M, mraidnt.sys, version 4.05, or later (all drivers obtained from Navigator CD-ROM, version L.20.00, or later) Server internal drive bays, or HP external drive cabinet (e.g., HP Rack Storage/12) Must be HP Any HP cables that meet SCSI specifications, and any SCSI bus speed Any Version M.04.00, or later Microsoft Window NTâ Server 4.0, Enterprise Edition SP5 or SP6a and Microsoftâ hotfix Q316743. Please refer to the Microsoftâ product support article at: http://support.microsoft.com/default.aspx?scid=KB;ENUS;q316743&ID=KB;EN-US;q316743 Redundant power distribution units (PDUs) are recommended. See power cabling diagram on page 6. Shared Storage Configuration Parameter Specification Controller Model Number of controllers HP NetRAID-2M Controller, Model P3411A, or P3475A One BIOS Disabled Firmware Version H.01.08 (firmware obtained from Navigator CD-ROM, version M.03.00, or later) Driver Mraidnt.sys, version 4.05 (driver obtained from Navigator CD-ROM, version L.20.00, or later) NetRAID Assistant Version B.01.04, or later (software obtained from Navigator CD-ROM, version L.20.00, or later) SCSI ID 6, 7 Channels 0, 1 RAID levels 1, 5, 10, 50 10/21/02 2