HP LH4r HP Netserver LPr SCSI Cable Kit Guide - Page 4
Install the New SCSI Cable, New SCSI Cable, Cable Guide, Embedded SCSI, Controller Con
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
HP NetServer LPr SCSI Cable Kit Guide Install the New SCSI Cable 7. On the new SCSI cable, connect the end of the new SCSI cable labeled "To EXT SCSI Port" to the SCSI repeater card, as shown in Figure 6. To do so, squeeze the extractors on the connector, as shown in Figure 3, and then push the connector on until it clicks into place. 8. Thread the connector on the new SCSI cable labeled "To Riser Board" through the cable guide, and connect it to the embedded SCSI controller on the I/O board (riser board), as shown in Figure 6. To connect it, squeeze the extractors on the connector, as shown in Figure 3, and then push the connector on until it clicks into place. 9. Peel the backing off the adhesive on the terminator block on the new SCSI cable. Press the adhesive side of the terminator block onto the bottom of the NetServer at the location marked by scribe lines, as shown in Figure 6. I/O Board (Riser Board) New SCSI Cable Cable Guide Cable Guide New SCSI Cable Embedded SCSI Controller Connector Connect "To Riser Board" Connector on New SCSI Cable to Embedded SCSI Controller Connector SCSI Repeater Card Connect "To EXT SCSI Port" Connector on New SCSI Cable to SCSI Repeater Card Peel Backing off Adhesive on Bottom of Terminator Block, and Attach Terminator Block to Bottom of NetServer Inside Scribe Lines Figure 6. Install the New SCSI Cable 4