HP LH4r hp netserver lt 6000r netraid-4m config guide — for Micro - Page 3
Enclosure, Cables, Power distribution
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
lt6000rnt4m Shared Storage Configuration Parameter NetRAID-4M FAST SCSI ID Channels RAID levels Containers Configuration options Enclosure Disk drives Number of cabinets Model Status SCSI ID Disk SCSI IDs Cables SCSI Power distribution Layout Specification Ultra2 models - Version 2.4-0, or later (software obtained from Navigator CD-ROM, version L.20.00, or later) Ultra3 models - Version 2.4-1, displayed in FAST as version 4605, or later (software obtained from Navigator CD-ROM, version M.04.00, or later) 6, 7 0, 1, 2, 3 All fault-tolerant RAID types supported by controller: 1, 5, 10 (stripe set of mirror sets RAID 0/1), 50 (stripe set of RAID-5 sets), volume set of mirror sets, volume set of RAID-5 sets Single-level or multi-level Must be fault-tolerant Eight, maximum, per cluster Write cache disabled Clustering enabled Domain validation enabled Any HP drive supported by storage enclosure. Any combination of HP disk models is allowed in a diskset, on a SCSI channel, or in a cluster. Up to eight Rack Storage/12 D5989B, containing two D6025B SCSI controller cards, or Rack Storage/12 D5989C, containing two D6025C SCSI controller cards 5 (fixed) 0-3, 8-15 (fixed) Any two HP LVD SCSI offset cables per RS/12 from the following list: 1 meter D7131A 2.5 meter D6020A 5 meter D6982A 10 meter D6983A See SCSI cabling diagram on page 5. Redundant power distribution units (PDUs) are recommended. See power cabling diagram on page 6. Microsoft® and HP Certified Server Configuration Parameter I/O card slot Network interfaces Boot device Specification PCI slot 5, NetRAID-4M shared storage controller PCI slot 2, model D5013B, client LAN Embedded DAC 1/28/02 3