HP LH4r HP Netserver LXr 8000 for Compaq 4000/7000 Racks - Page 10

HP LH4r - NetServer - 256 MB RAM Manual

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Chapter 2 Warranty and Support Terms used in this document are defined in the table below. Term Definition Rack nut Slide Slide mounting flange Rack (rack enclosure) EIA unit Single nut designed to clip behind the rack column and accept a screw through the hole in the column. Extendible side bracket that is attached to the rack enclosure columns, onto which the NetServer is mounted. Consists of a stationary component, and an extendible member (see Figure 3-3). Allows access to the NetServer after it is installed in the rack chassis. Mounting flange located at either end of the slide (see Figure 3-3). The equipment enclosure into which the NetServer will be installed. Industry standard measurement (1.75 inches / 44.45 mm), consisting of four vertical mounting holes in a rack column. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Chapter 2
Warranty and Support
6
Terms used in this document are defined in the table below.
Term
Definition
Rack nut
Single nut designed to clip behind the rack column and
accept a screw through the hole in the column.
Slide
Extendible side bracket that is attached to the rack
enclosure columns, onto which the NetServer is mounted.
Consists of a stationary component, and an extendible
member (see Figure 3-3). Allows access to the NetServer
after it is installed in the rack chassis.
Slide mounting flange
Mounting flange located at either end of the slide (see
Figure 3-3).
Rack (rack enclosure)
The equipment enclosure into which the NetServer will be
installed.
EIA unit
Industry standard measurement (1.75 inches / 44.45 mm),
consisting of four vertical mounting holes in a rack column.