HP LH4r HP Netserver LXr Pro8 SCSI Extender - Page 19
When you finish servicing the HP NetServer, move to the front of
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Chapter 2 Installing the SCSI Extender 4. Reattach the rear access panel. a. Lower the panel into place. A slotted flange extends from the top of the panel on either side. Lower the slots over the matching tabs on the satellite chassis. b. Tighten the three captive screws. 5. Reattach the lower fan module: a. On each side of the back of the fan module are two slots. Line these slots up with the flanges on the fan's mounting rails. b. Push the fan module onto the mounting rails until it clicks into place. 6. Reattach the satellite chassis to the base chassis: a. When you finish servicing the HP NetServer, move to the front of the server and unlatch all four power supplies. (If the front bezel is in place, remove it.) b. At the rear, insert the satellite chassis. To do so, push in the release latch for each slide (Figure 2-9). While holding the latches down, push the satellite part way onto the base, so that the latches can no longer engage. 15