HP LH4r HP Netserver Mass Storage Upgrade Guide - Page 27
Drive Spacer
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Chapter 2 Installation Below are single-bus (no duplex board) hot-swap drive configurations and SCSI addresses (IDs) for the secondary cage in a rack-mounted HP NetServer. Load drive modules with all necessary drive spacers starting at the bottom of the cage, as described in "Installing Hot-Swap Drives" later in this chapter. Filler panels must occupy all locations without disk drive modules. Drive Spacer Drive Spacer Drive Spacer Drive Spacer 10 11 12 13 14 15 10 12 14 10 11 12 14 15 Load Load Load 10 12 13 14 15 10 12 14 15 10 12 13 15 Drive Spacer Drive Spacer Drive Spacer Drive Spacer Drive Spacer Figure 2-13. SCSI IDs for Single-Bus Configurations in Rack Orientation 23
Chapter 2
Installation
23
Below are single-bus (no duplex board) hot-swap drive configurations and SCSI
addresses (IDs) for the secondary cage in a rack-mounted HP NetServer. Load
drive modules with all necessary drive spacers starting at the bottom of the cage,
as described in "Installing Hot-Swap Drives" later in this chapter. Filler panels
must
occupy all locations without disk drive modules.
10
10
12
13 14 15
10
12
14 15
10
12
13
15
11 12 13 14 15
10
12
14
10 11
12
14 15
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Load
Load
Load
Figure 2-13. SCSI IDs for Single-Bus Configurations in Rack Orientation