HP LH4r Ultra Hot Swap Hard Disk Drive and Tray - Page 7

Chapter 1 Installation Procedure Figure 1-2. Shipping Plug Installing the Hot Swap Hard Disk Drive CAUTION Use one of the six (6) vertical shelves in the system. Do not attempt to install the hot swap hard disk drive in the horizontal shelves. Protect the hot swap hard disk drive from static electricity by leaving it in its antistatic bag until you are ready to install it. Before handling the hard disk drive, touch any unpainted metal surface to discharge static electricity. When you remove the hard disk drive from the antistatic bag, handle it only by the frame. Do not touch the electrical components. Place the hard disk drive on the antistatic bag whenever you set it down. 1. If there is a filler panel in the disk shelf, remove that panel. 2. On the hot swap hard disk drive, press the locking tab down, and lift the lever up as far as it can go. (See Figure 1-3.) Lifting the lever retracts the locking pin at the top of the hard disk drive. 3