HP LH4r Ultra Hot Swap Hard Disk Drive and Tray - Page 8
Removing the Hot Swap Hard Disk Drive
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 1 Installation Procedure 3. Holding the hard disk drive as shown in Figure 1-3, slide the hot swap hard disk drive slowly into the shelf until it stops. 4. Press the lever down as far as it will go. Figure 1-3. Installing the Hot Swap Hard Disk Drive Removing the Hot Swap Hard Disk Drive 1. To unlock the hot swap hard disk drive, push the tab down and then lift the front lever. 2. Pull the hard disk drive out about an inch (2.5 cm) to break the power connection. 3. Wait about 30 seconds for the hard disk drive to stop spinning and the drive heads to park. 4. Use your hand to support the bottom of the hard disk drive, as shown in Figure 1-4. Slowly pull the hard disk drive straight out. Do not allow the hard disk drive to fall. 5. Turn the hard disk drive slowly to its horizontal storage orientation. 6. Place the hard disk drive in an electrostatic protected container. Do not stack hot swap hard disk drives. 4