HP LH6000r HP Netserver LH 3000 Rack Cabling Guide - Page 21
Power Cables and Components Available
View all HP LH6000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Chapter 2 Rack Cabling References Power Cables and Components Available When components are installed in a rack, a power supply subsystem for the rack is required. HP recommends the NetServer LH 3000r be connected as follows: • connected to a Power Distribution Unit (PDU) -- see Figure 2-1 • through an Uninterruptible Power Supply (UPS) -- see Table 2-1 • to a properly protected branch circuit or circuits -- see "Site Preparation -Circuit Breakers" in Chapter 1 NOTE A Redundant Switch is available for use between the UPS and the branch circuit or between the PDU and the branch circuit. More information is listed in Table 2-2 and in Appendix B. Table 2-2 lists details of the cables, components, plugs and receptacles for the rack power supply subsystems for the HP NetServer LH 3000r. Table 2-1. UPS Models and Power Ratings Uninterruptible Power Supplies APC Model NS3000RM3U NS2200RM3U NS3000RMT3U NS2200RMI3U NS3000RMI3U Voltage 100/200 VAC 100/120 VAC3 200/208 VAC 230/240 VAC 230/240 VAC Power (VA)1 3000 2200 3000 2200 3000 Power (Watts)2 2250 1600 2250 1600 2250 Note 1. Ensure UPS Volt Amps rating is not exceeded. Add power in Volt Amps of each component and connect no more than those the UPS supports. Note 2. Also ensure UPS Wattage rating is not exceeded. Add power in Watts of each component and connect no more than those the UPS supports. Note 3. Consult American Power Conversion Corporation (APC) for information on 100 V UPS for Japan. 17