HP LaserJet Pro 300 HP LaserJet Pro 300 and 400 Color M351 and M451 - User Gui - Page 67
Con IP network settings with Windows, View or change network settings
View all HP LaserJet Pro 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Configure IP network settings with Windows View or change network settings Use the embedded Web server to view or change IP configuration settings. 1. Print a configuration page, and locate the IP address. ● If you are using IPv4, the IP address contains only digits. It has this format: xxx.xxx.xxx.xxx ● If you are using IPv6, the IP address is a hexadecimal combination of characters and digits. It has a format similar to this: xxxx::xxxx:xxxx:xxxx:xxxx 2. To open the HP Embedded Web Server, type the IP address (IPv4) into the address line of a Web browser. For IPv6, use the protocol established by the Web browser for entering IPv6 addresses. 3. Click the Networking tab to obtain network information. You can change settings as needed. Set or change the product password Use the HP Embedded Web Server to set a password or change an existing password for a product on a network. 1. Type the product IP address into the address line of a Web browser. Click the Networking tab, and click the Security link. NOTE: If a password has previously been set, you are prompted to type the password. Type the password, and then click the Apply button. 2. Type the new password in the New Password box and in the Verify password box. 3. At the bottom of the window, click the Apply button to save the password. Manually configure IPv4 TCP/IP parameters from the control panel 1. At the control panel, press the OK button to open the menus. 2. Open the following menus: ● Network Setup ● TCP IP Config ● Manual 3. Use the arrow buttons to change each digit of the IP address. Press the OK button to move to the next digit. ENWW Connect to a network with Windows 49