HP Latex R2000 Introductory Information - Page 10

7. Extra-low-friction protective film 8. Bases for shims 9. Back ends (2) Setup procedure The edge holders must be assembled before use. The parts shown in the illustrations are provided in the substrate edge holder kit. The print-zone module should be chosen according to the thickness of the substrate that you intend to use. Look at the label on each print-zone module to identify the one you need. To assemble the edge holders, look for a flat surface on which to place the parts. 1. Pick up the print-zone module that you have decided to use, and unfold the hinge. 2. Overlap an input module with the print-zone module and attach the two parts with the screws provided. 3. Repeat the operation at the other end of the print-zone module, to attach it to the output module. 4. Repeat both operations to assemble the second edge holder. Once the edge holders are assembled, they can be kept in the box provided. IMPORTANT: If you are working with substrates thicker than 0.5 mm (0.02 in), there are shims to be installed on the edge holders that help you to handle thicker substrates. See the printer's user guide for more information about this installation process. 8 HP Latex R Printer Series Substrate Edge Holder Kit ENWW