HP MSL4048 HP StorageWorks MSL2024 Tape Library firmware release notes Version - Page 3
Description, Product models, Languages, Enhancements, Fixes - library support
UPC - 882780742215
View all HP MSL4048 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Description This release includes updated firmware for the HP StorageWorks MSL2024 Tape Library. The Library firmware can be updated through any of the following methods: • Remote management interface (RMI). • Operator control panel (OCP). • HP Library and Tape Tools (L&TT). Library firmware version • 4.00 Update recommendation Recommended Supersedes All earlier versions of Library firmware. Product models All HP StorageWorks MSL2024 Tape Libraries. Languages • English (American) • English (International) Enhancements • Support added for Internet Protocol version 6 (IPv6). • Support added for partitioning the Library into logical libraries. The Tape Library can have up to as many logical libraries as there are tape drives. • Support added for the 1/8 G2 and MSL Encryption Kit, which is a solution for generating and storing encryption keys to write and restore encrypted data on LTO-4 media with LTO-4 tape drives. • Support added for the Ultrium 1760 parallel SCSI half-height tape drive. • Support added for SNMP version 2. • Ability to save and restore the Library configuration settings to a USB flash drive (from the OCP) or a file (from the RMI). • The number of allowed reserved slots is increased from 9 to 22. Fixes • Fixed a case where the Library could appear unresponsive when used with network security programs that constantly check the security status of all network ports. Usually Drive Communication (code: F1 xx) errors were the last entries in the library logs. • Fixed a case where the Library could appear unresponsive after the operator issued a command from the OCP to remove a magazine but the magazine was not removed. • Fixed a case where the time stamp in the library logs would be recorded as one day earlier than the library time. • Fixed a case where error retry Code 88 00 (setting of sled motor parameters failed) was incorrectly logged during the power up sequence. • Fixed a case where error code 9B (sled position sensor not found) was reported at ambient temperatures below 10 C when the mailslot did not pop out more than 15 mm. • Fixed a case where the Library would report Not Ready after running the Demo Test. • Improved an error message in the Wellness test when an upper corner slot is empty. HP StorageWorks MSL2024 Tape Library firmware release notes 3