HP Mini 110-3500 HP Mini 110, Compaq Mini CQ10 and HP Mini 1103 - Maintenance - Page 51
WWAN and GPS modules (select models only - wlan will not turn on
View all HP Mini 110-3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
WWAN and GPS modules (select models only) NOTE: The WWAN module and the GPS module are very similar. Either can populate the WWAN slot. Description HP lc 2010 Mobile Broadband Module (HP Mini 110/Compaq Mini CQ10 models only) HP lc 2000 Mobile Broadband Module (HP Mini 110/Compaq Mini CQ10 models only) Qualcomm Gobi 2000 3G WWAN module (select models only) HP hs2320 HSPA Mobile Broadband Module (HP Mini 1103 models only) Spare part number 612600-001 612599-001 531993-001 574248-001 CAUTION: The WWAN module and the WLAN module are not interchangeable. CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the computer by the governmental agency that regulates wireless devices in your country or region. If you replace the module and then receive a warning message, remove the module to restore device functionality, and then contact technical support. Before removing the WWAN or GPS module, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the following components: a. Battery (see Battery on page 35). b. Service access cover (see Service access cover on page 38). Remove the WWAN or GPS module: 1. Disconnect the antenna cable or cables (1) from the WWAN or GPS module. NOTE: The antenna cable with the red label is connected to the WWAN module "Main" terminal. The antenna cable with the blue label is connected to the WWAN or GPS module "Aux" terminal. NOTE: The GPS module does not use the Main cable, therefore the Main cable is not connected. When you work with the GPS module, it is important to keep the plastic tubing that covers the Main cable in place. 2. Remove the 2 Phillips 2.0×3.0 screws (2) that secure the WWAN or GPS module to the system board. (The module tilts up.) Component replacement procedures 43