HP Mini 210-1033VU HP Mini 2102, HP Mini 210, and Compaq Mini 210 - Maintenanc - Page 62
Remove the keyboard, Release the zero insertion force ZIF connector
View all HP Mini 210-1033VU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Remove the keyboard: 1. Remove the three Phillips PM2.0×6.0 screws that secure the keyboard to the computer. 2. Turn the computer right-side up, with the front toward you. 3. Open the computer as far as it will open. 4. Lift the rear edge of the keyboard (1) until it rests at an angle. 5. Slide the keyboard (2) back until the keyboard cable and connector are accessible. 6. Release the zero insertion force (ZIF) connector (3) to which the keyboard cable is attached, and then disconnect the keyboard cable (4) from the system board. 7. Remove the keyboard. 54 Chapter 4 Removal and replacement procedures
Remove the keyboard:
1.
Remove the three Phillips PM2.0×6.0 screws that secure the keyboard to the computer.
2.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as it will open.
4.
Lift the rear edge of the keyboard
(1)
until it rests at an angle.
5.
Slide the keyboard
(2)
back until the keyboard cable and connector are accessible.
6.
Release the zero insertion force (ZIF) connector
(3)
to which the keyboard cable is attached, and
then disconnect the keyboard cable
(4)
from the system board.
7.
Remove the keyboard.
54
Chapter 4
Removal and replacement procedures