HP Mini CQ10-688NR HP Mini 110 and Compaq Mini CQ10 - Maintenance and Service - Page 78
and the fan/heat sink assembly
![]() |
View all HP Mini CQ10-688NR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
4. Remove the fan/heat sink assembly (4). NOTE: Due to the adhesive quality of the thermal material located between the fan/heat sink assembly and system board components, it may be necessary to move the fan/heat sink assembly from side to side to detach it from the system board. NOTE: The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink assembly and the system board each time the fan/heat sink assembly is removed: Thermal paste is used on the processor (1) and the fan/heat sink assembly section (2) that services it. Reverse this procedure to install the fan/heat sink assembly. 70 Chapter 4 Removal and replacement procedures
![](/manual_guide/products/hewlettpackard-mini-1103700-hp-mini-110-compaq-mini-cq10-maintenance-service-guide-816502c/78.png)
4.
Remove the fan/heat sink assembly
(4)
.
NOTE:
Due to the adhesive quality of the thermal material located between the fan/heat sink
assembly and system board components, it may be necessary to move the fan/heat sink assembly
from side to side to detach it from the system board.
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink
assembly and the system board each time the fan/heat sink assembly is removed: Thermal paste is
used on the processor
(1)
and the fan/heat sink assembly section
(2)
that services it.
Reverse this procedure to install the fan/heat sink assembly.
70
Chapter 4
Removal and replacement procedures