HP Model 712/100 hp DDS-3 tape drive user's guide (a1658-90702) - Page 25

Introduction, Removing a Bezel from the DDS-3 Drive

Get HP Model 712/100 - Workstation PDF manuals and user guides View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Introduction To remove a bezel from a drive, use a straight blade screwdriver to lift the bezel tabs from the top of the drive, and push in the tabs at the sides of the drive. Refer to Figure 1-6. Figure 1-6. Removing a Bezel from the DDS-3 Drive To add expansion brackets to the drive or to remove them, use a T10 torx wrench to either tighten or remove the four torx screws that hold each expansion bracket to the drive. Refer to Figure 1-7. 1-15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
Introduction
1–15
To remove a bezel from a drive, use a straight blade screwdriver to lift the bezel tabs
from the top of the drive, and push in the tabs at the sides of the drive. Refer to Figure
1–6.
Figure 1–6. Removing a Bezel from the DDS-3 Drive
To add expansion brackets to the drive or to remove them, use a T10 torx wrench to
either tighten or remove the four torx screws that hold each expansion bracket to the
drive. Refer to Figure 1–7.