HP NetServer LH 3000 HP Netserver Mass Storage Upgrade Guide - Page 20
To attach the 68-pin connector, press on the center of the connector strain
![]() |
View all HP NetServer LH 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Chapter 2 Installation 2. Connect the SCSI cable's 68-pin connector labeled "To I/O Board" to the SCSI B connector on the I/O baseboard, as shown in Figure 2-6. To attach the 68-pin connector, press on the center of the connector strain relief and press the connector into place, as shown in Figure 2-7. Two clicks indicates the connector is properly installed. Figure 2-7. Attach SCSI Cable Connector 16
![](/manual_guide/products/hewlettpackard-lh3000r-hp-netserver-mass-storage-upgrade-guide-5d11c7d/20.png)
Chapter 2
Installation
16
2.
Connect the SCSI cable’s 68-pin connector labeled "To I/O Board" to the
SCSI B connector on the I/O baseboard, as shown in Figure 2-6.
To attach the 68-pin connector, press on the center of the connector strain
relief and press the connector into place, as shown in Figure 2-7. Two
clicks indicates the connector is properly installed.
Figure 2-7. Attach SCSI Cable Connector