HP NetServer LT 6000r HP Netserver Ultra3 SCSI HBA Guide - Page 29
Microsoft Windows NT, Installation
View all HP NetServer LT 6000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
3 Microsoft Windows NT Installation This chapter explains how to install the HP Ultra3 Family Manager Set driver adpu160m.sys for Windows NT. If you are performing a first time Windows NT installation, see "Installing the Driver When Installing Windows NT" in the next section. If Windows NT is already installed in your system, see "Installing the Driver When Windows NT is Already Installed" on page 24. Installing the Driver When Installing Windows NT The adpu160m.sys driver is not embedded on the Windows NT 4.0 installation disks (or CD-ROM) and must be added during Windows NT installation. Completing a Fresh Windows NT 4.0 Installation From Floppy Disk 1. Start your system with the Windows NT Boot Disk in the floppy disk drive. 2. When prompted, insert disk #2 in your floppy disk drive. After a few moments you will see a blue screen. To setup Windows NT now, press Enter. 3. Press S to skip auto-detection of your SCSI host adapter. 4. Press S again to specify an additional device. 5. Press Enter to select Others; insert the HP Ultra3 Family Manager Set disk for Windows NT into your floppy disk drive. 6. Using the arrow keys, select the following driver and press Enter: Adaptec Ultra3 PCI SCSI Controller (NT4.0) 7. To add other host adapters, press S and repeat from Step 5 for each addi- tional adapter and insert the appropriate driver disk. 23