HP NetServer LXr Pro8 Installation Guide for Compaq 4000/7000 Racks - Page 15

Installing the NetServer, Use two people when moving the NetServer or lifting it into

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Front Column Rail Flange Installation Rack Nuts Figure 3-4. Mounting a Rail To a Column Installing the NetServer WARNING To prevent the rack from tipping over, be sure that the stabilizing, anti-tip feature is installed on this rack enclosure (see Figure 1-2). 1. Remove the hot-swap disk modules from the NetServer before lifting it into the rack enclosure. WARNING Use two people when moving the NetServer or lifting it into the rack. 2. Using two people, lift the NetServer and move the NetServer in between the rails. Slide it all the way back until the mounting tabs on either side of the NetServer front panel rest against the equipment rack columns (see Figure 3-5). 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
Installation
11
Rail Flange
Front Column
Rack
Nuts
Figure 3-4.
Mounting a Rail To a Column
Installing the NetServer
WARNING
To prevent the rack from tipping over, be sure that the
stabilizing, anti-tip feature is installed on this rack enclosure
(see Figure 1-2).
1.
Remove the hot-swap disk modules from the NetServer before lifting it into
the rack enclosure.
WARNING
Use two people when moving the NetServer or lifting it into
the rack.
2.
Using two people, lift the NetServer and move the NetServer in between
the rails. Slide it all the way back until the mounting tabs on either side of
the NetServer front panel rest against the equipment rack columns (see
Figure 3-5).