HP NetServer LXr Pro8 Installation Guide for Compaq 4000/7000 Racks - Page 17

Installing the Bezel, order to install the bezel for use with a Compaq rack, the HP-bezel anchors

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Installation 3. Install two screws through the two holes on either side of the NetServer front panel (see Figure 3-6) and into the rack nuts in the columns (previously installed). Figure 3-6. Securing the NetServer to the Rack Columns 4. Replace the hot-swap disk modules into the NetServer. Installing the Bezel This NetServer ships with bezel anchors for use with an HP-rack bezel. In order to install the bezel for use with a Compaq rack, the HP-bezel anchors must be replaced with Compaq-bezel anchors. 1. Remove the two screws that secure each bezel anchor to each end of the NetServer front panel, and remove the anchors (see Figure 3-7). 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
Installation
13
3.
Install two screws through the two holes on either side of the NetServer
front panel (see Figure 3-6) and into the rack nuts in the columns
(previously installed).
Figure 3-6.
Securing the NetServer to the Rack Columns
4.
Replace the hot-swap disk modules into the NetServer.
Installing the Bezel
This NetServer ships with bezel anchors for use with an HP-rack bezel. In
order to install the bezel for use with a Compaq rack, the HP-bezel anchors
must be replaced with Compaq-bezel anchors.
1.
Remove the two screws that secure each bezel anchor to each end of the
NetServer front panel, and remove the anchors (see Figure 3-7).