HP Officejet g55 HP OfficeJet G55 - (English) Quick Setup Poster for Windows - Page 2

HP OfficeJet G55 Quick Setup Poster, - troubleshooting

Page 2 highlights

7 Insert color print cartridge a Remove the color print cartridge (wider one) from its packaging and, being careful to touch only the black plastic, gently remove both the green pull tab and the blue tape covering the nozzles. b Push the color print cartridge firmly down into the slot on the left. Lower the left print-cartridge latch down onto the top of the cartridge, and push down until the latch locks firmly into place. c Pull the handle down to close the door. CAUTION: Do not touch or remove the goldcolored contacts. 8 Select your language Look at your display for the language list. Enter the code for your language, and then confirm your selection. Keypad Display 9 Print an alignment page Make sure paper is loaded in your HP OfficeJet. The message "Press ENTER to Align Cartridges" appears in the display. Press the ENTER key to enable the HP OfficeJet to perform the alignment. After a page prints, the alignment is complete. Look at the alignment page for green check marks, and then recycle or discard the page. ENTER 10 Configure your software a Turn on your computer. Windows software automatically configures your HP OfficeJet. A series of Microsoft "New Hardware Found" messages appear. The configuration may take a few moments. Note to USB Users: These screens may have already appeared on your PC while you were setting up. Note to Windows NT 4 Users: The message, "HP OfficeJet G Series Configuration done" appears instead. See step b. .If you need more help, see Chapter 1, "Additional Setup Information" in the Basic Guide. b Click OK to complete the software setup. If this screen does not appear, see Chapter 1, "Additional Setup Information" in the Basic Guide. 11 Congratulations! You can now print, copy, and scan with your new HP OfficeJet. Additional a software programs may be available with your HP OfficeJet. To install the programs, do the following: Remove and reinsert your HP OfficeJet installation CD in your CD-ROM drive. b The HP OfficeJet software installation menu appears. The Productivity Section lists additional programs you can install. Click the program name and follow the onscreen installation instructions. 12 Get to know the front panel Here are some features of your new HP OfficeJet: Use the ENTER key to make selections. Use the Scan To key to select a specific PC or program destination. Use the Start Scan key after you make a selection from the Scan To list. Use the Special Features key to access copying features, such as Fit to Page, Poster and Clone. Select one of these keys to begin copying. Use the Keypad to enter the number of copies or change the reduce/enlarge percentage. *C6736-90116* *C6736-90116* C6736-90116 Copyright Hewlett-Packard Company 2000. Printed in the USA, Germany, or Singapore. HP OfficeJet G55 Quick Setup Poster, Page 2 For troubleshooting, refer to the HP OfficeJet G Series: Your Basic Guide and the HP OfficeJet G Series: Onscreen Guide. Save this sheet for future reference.

  • 1
  • 2

Copyright Hewlett-Packard Company 2000.
Printed in the USA, Germany, or Singapore.
For troubleshooting, refer to the
and
the
. Save this sheet for future reference.
HP OfficeJet G Series:
Your Basic Guide
HP OfficeJet G Series:
Onscreen Guide
HP OfficeJet G55 Quick Setup Poster, Page 2
Get to know the front panel
12
Congratulations!You can now print, copy, and scan with your new HP OfficeJet.
Additional
software
programs may
be available
with your HP
OfficeJet.
To install the programs, do the
following:
Remove and reinsert
your HP OfficeJet
installation CD
in your
CD-ROM
drive.
The HP OfficeJet software installation
menu appears. The Productivity Section
lists additional programs you can install.
Click the program name and follow the
onscreen installation instructions.
a
b
11
10
Turn on your computer.Windows software
automatically configures your HP OfficeJet.
A series of Microsoft “New Hardware Found”
messages appear. The configuration may
take a few moments.
Configure your software
Click
to complete the software setup.
If this screen does not appear, see
Chapter 1, “Additional Setup Information”
in the Basic Guide.
OK
Note to USB Users:
These screens may
have already appeared on your PC while you
were setting up.
Note to Windows NT 4 Users:
The message,
"HP OfficeJet G Series Configuration done"
appears instead. See step b.
a
b
Look at your display for the language list.
Enter the code for your language, and then
confirm your selection.
Select your language
8
Insert color print cartridge
Remove the color print cartridge (wider
one) from its packaging and, being careful
to touch only the black plastic, gently
remove both the green pull tab and the
blue tape covering the nozzles.
Push the color print cartridge firmly down into
the slot on the left. Lower the left print-cartridge
latch down onto the top of the cartridge, and
push down until the latch locks firmly into place.
CAUTION:
Do not touch
or remove
the gold-
colored
contacts.
a
b
7
Print an alignment page
9
Make sure paper is loaded in your
HP OfficeJet.
The message “Press
to
Align Cartridges” appears in the
display. Press the
key to
enable the HP OfficeJet to perform
the alignment. After a page prints,
the alignment is complete.
Look at the alignment page for
green check marks, and then
recycle or discard the page.
ENTER
ENTER
ENTER
Pull the handle down to close
the door.
c
.
If you need more help, see Chapter 1,
"Additional Setup Information" in the
Basic Guide.
Here are some
features of your
new HP OfficeJet:
Use the
key to make selections.
ENTER
Use the
key to select a specific PC or
program destination.
Scan To
Use the
key to access copying
features, such as Fit to Page, Poster and Clone.
Special Features
Use the
to enter the number of copies or
change the reduce/enlarge percentage.
Keypad
Keypad
Display
*C6736-90116*
*C6736-90116*
C6736-90116
Use the
key after you make a selection
from the Scan To list.
Start Scan
Select one of these keys to begin copying.