HP Officejet g85 HP OfficeJet G85 - (English) Quick Setup Poster for Windows - Page 1

HP OfficeJet G85 Quick Setup Poster 1 Install the software first a Open the carton. b Remove the HP OfficeJet installation CD from the tray. c Turn your computer on and insert the HP OfficeJet installation CD. d Click Install to begin. If the screen to the left does not e When prompted during f appear, go to the Windows taskbar, installation, take the click Start, and then choose Run. Product Tour. In the Run dialog box, type d:\setup.exe (substitute your CD- View the Product Tour to ROM drive letter for the "d"), and see all the features of your then click OK. new HP OfficeJet. After the tour, continue to step f Follow the onscreen installation to finish setup. instructions. Note: For more information during installation, click the Help button, if available. If Windows is using any of your files that need to be updated, Windows will shut down during installation. Leave your computer off until step 14 (Configure your software). Note: On the screen, you may be prompted to enter your cable type. A parallel cable is included in your carton. However, if your PC is equipped with a USB port and you are using Windows 98/2000, we recommend you purchase and use a high-speed (12Mbps) USB cable to increase performance. Check your PC's documentation to determine if you have a USB port. 2 Unpack your HP OfficeJet 3 Load paper a Remove the tray from the carton. b Remove the print c cartridges from the sides of the HP OfficeJet. print cartridges Rest the box on its side and pull out your HP OfficeJet. Remove any packaging or tape from the HP OfficeJet. d Verify that you have these additional key components. a b c power adapter phone cord power cord parallel cable print cartridges 4 Connect the cable a Connect your cable. Warning: Do not connect the USB cable and parallel cable at the same time. Parallel Cable Users: Connect the parallel cable, then go to step b. - or - USB Cable Users: Connect the USB cable from your HP OfficeJet to your PC, then go to step 5. b Parallel Cable Users: Tighten the screws on the cable so that it is securely attached to your PC. 5 Secure the cord Make sure the Automatic Document Feeder cord is securely connected to the unit. Check connection here 6 Connect the power cord 1 3 Connect the power supply and the adapter. 2 7 Connect the phone cord Connect the phone/fax cord to the HP OfficeJet and then to the wall jack. 8 Connect office equipment (optional) This diagram shows a possible configuration for connecting additional office equipment. For each piece of office equipment you are connecting to the HP OfficeJet, remove a plastic tab from the phone/fax connector. If you connect a PC modem, turn off its fax-receive feature. See your Onscreen Guide for information on tone versus pulse dialing and features such as distinctive ring or voice mail. 9 Turn on your HP OfficeJet http://www.hp.com/go/all-in-one Turn page over for additional setup.