HP P10000 HP 3PAR HP-UX 11i v2, v3 Implementation Guide (QL226-96021, August 2 - Page 41
If an InServ node is rebooted or InServ Cluster is rebooted and the connection type is Direct
View all HP P10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
6. To find the storage volume serial number for the corresponding disk id on the HP-UX host, use the cstm command. The HP Online diagnostic tool must be installed to access the cstm command. For example: # cstm # selclass type disk # info # infolog ... Hardware path: 0/2/0/0.8.0.0.0.0.4 The selected device is not supported by this tool. Inaccurate information could be displayed by the tool. Product Id: VV Vendor: 3PARdata Device Type: SCSI Disk Firmware Rev: 0000 Device Qualifier: 3PARdataVV Logical Unit: 4 Serial Number: 003B003E Capacity (M Byte): 4096.00 Block Size: 512 Max Block Address: 8388607 ... Check the ioscan -fun disk for the given hardware path and use the HP 3PAR Storage System CLI command showvlun -lvw or showvv -d to get the volume name. The data which matches is in bold font: # showvlun -lvw -host ... Active VLUNs Lun VVname -----VV_WWN----- Host ---- Host_WWN---- Port Type 4 hpuxN.0 50002AC0003B003E hp 50060B0000101A4C 1:0:3 host 4 hpuxN.0 50002AC0003B003E hp 50060B00000670A8 2:1:1 host ... 7. If an InServ node is rebooted or InServ Cluster is rebooted and the connection type is Direct, performing an ioscan or I/O on any storage volume connected to the Agilent A6795A, AH402A HBA is required in order to see the host WWN with the showhost command. This is because the HPUX host driver logs into the target port only on performing one of the above operations. Using the ioscan Command with Multipathing Software to Verify HBA Connections 41