HP P2000 HP MSA2000 3.5-inch Large Form Factor Drive Enclosure I/O Module Firm - Page 9
Installing firmware using FTP, Supersedes history - specifications
View all HP P2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installing firmware using FTP 1. Place the downloaded firmware package in a temporary directory. 2. If using a Smart Component, extract the contents of the Smart Component. In Windows - Click Extract on the first screen of the Smart Component. In Linux - Enter ./CPxxxxxx.scexe --unpack= to extract the contents of the Smart Component to the folder. For example,./CP123456.scexe -unpack=extract_here 3. Locate the firmware file in the extracted folder. The firmware filename is in the following format: O3xxBxx-01.bin 4. Do one of the following: • To update all modules, proceed to step 5. • To update specific modules, do the following to determine the address of each module to update: In the CLI, display the addresses by entering the show enclosures command. The needed data is displayed in the columns labeled EMP A CH:ID Rev and EMP B CH:ID Rev. 5. In the SMU, prepare to use FTP: a. Determine the network-port IP addresses of the system controllers. b. Verify that the system FTP service is enabled. c. Verify that the user you will log in as has permission to use the FTP interface and has management access rights. 6. In single-domain environments, stop al I/O to the vdisks before starting the firmware update. 7. Open a command prompt (Windows) or a terminal window (UNIX), and navigate to the directory containing the firmware file to load. a. Enter ftp . (For example: ftp 10.1.0.9) b. Log in as an FTP user (user = ftp, password = flash). c. Enter one of the following commands: • To update all detected modules, enter: put encl flash. For example: put O3xxBxx.bin encl flash • To update a specific module, enter: put encl:: flash. For example: put O3xxBxx.bin encl:0:15 flash 8. If needed, repeat these steps to load the firmware on additional modules. 9. Quit the FTP session. 10. In the SMU display, verify that the proper firmware version appears for each module. Supersedes history Firmware version O320B07 O320B02 O300B28 Effective date June 2011 Release date June 2011 June 2010 February 2010 Supersedes history 9